Mounting and Finishing Photographs - Part 6 (Equipment)
Tools for the job: Mat cutter with extension arm, angled cutters for the window, straight cutters for mountboard and foamboard, pencil, duster (this gets used a lot), cutting mat to prevent damage to table when putting down tools , Framers tape in dispenser, ATG tape gun, good quality light source (anglepoise lamp) - all on a table big enough to take a sheet of mountboard.I have had a few questions about the equipment and suppliers I use so here are a few details for you. If you need to know anything else..just ask.
For cutting mounts I use a mat master 860 - from FrameCo. The squaring arm (I added the extended one a while back) makes cutting backing boards and mats to size a doddle. Frameco give great customer service: my first cutter developed a fault (well out of warranty) , I phoned them up and they were happy to send me a replacement.
For sticking the mat to the backing board then its a very good idea to use an ATG Tape Gun, so much easier and quicker than using double sided tape.
For embossing the limited edition certificates, I use a stamp from oyez which is individual engraved with my company name & "Limited Edition". I was really impressed when this was delivered less than 24 hours after I ordered it.
I buy all my framing Supplies (mountboard, foamboard, blades, tapes, wire,etc) in bulk from Lion.
Other posts in this series (Mounting and Finishing Photographs)
Part 1 - Introduction
Part 2 - Preparation
Part 3 - Mount Cutting
Part 4 - Final Assembly
Part 5 - Framing
Part 6 - Equipment
Part 7 - Conclusion
Labels: Equipment, framing, mating, mounting, Mounting and Finishing Photographs, presentation
posted by Chris Shepherd at
08:00
0 Comments:
Post a Comment
Links to this post:
Create a Link
<< Home